S&C IntelliRupter PulseCloser Fault Interrupter, Операция

Страница: 19 / 31

S&C Instruction Sheet 766-540 19
Operation Using IntelliLink® Setup Software
• The OPEN/CLOSE/READY lever is in the Ready position.
• A General profile is active (for example, the Hot Line Tag mode is not applied).
• The Loop Restoration feature is enabled on both the Operation screen and for the
presently active General profile.
• The IntelliRupter fault interrupter is not in an Error state.
Timing Indicator
The
Timing
indicator shows when the
Loop Restoration
timers are running. If the
Timing indicator is in the On state, the IntelliRupter fault interrupter is testing and some
of the conditions for the
Ready
status may not be valid.
Reconfigured Indicator
The Loop Restoration Reconfigured status is indicated when:
• An IntelliRupter fault interrupter configured for a Normally Closed operation is
opened by a Loop Restoration operation
• An IntelliRupter fault interrupter is configured for a Normally Closed operation but
is serving load in the opposite direction because of a Loop Restoration operation
• An IntelliRupter fault interrupter configured for a Normally Closed operation is
closed by a Loop Restoration operation
Communication Enhanced Coordination (CEC) Status
Ready Indicator
The
Ready
status is indicated with red text when the IntelliRupter fault interrupter is a
member of a CEC Pair , CEC mode is enabled, the correct General profile is active, and
there are no
Error
conditions.
To enable CEC status information to the Operations screen, both the Coordination
Mode
setpoint in one or more of the general profiles must be set to the
Communica-
tion Enhanced Coordination feature found on the Setup>Protection>General Profile
1-4>Direction 1 Current>TCC’s for Coordination screen, and the
Mode of Opera-
tion setpoint must be set to the IntelliTeam SG feature found on the Setup>General>
Site-Related screen.
Shift X Indicator
Communication Enhanced Coordination Shift for X Terminal— On when the
IntelliRupter fault interrupter has shifted to the slower curve for the X terminal.
Otherwise, off.
Shift Y Indicator
Communication Enhanced Coordination Shift for Y Terminal— On when the
IntelliRupter has shifted to the slower curve for the Y terminal. Otherwise, off.
OPEN and CLOSE Buttons
These buttons issue an Open or Close command when device operation is authorized.
Single-Phase Operation Buttons
When “Single-Phase Operation Is Active” is displayed and device operation is authorized,
one phase can be manually operated by selecting that phase and clicking on the
Open
or Close button.
1-Phase Operation
This function enables or blocks both manual and automatic Single-Phase operations.