NETWORK CAMERA
User Guide
20
NETWORK CAMERA
User Guide
21
※
The stand fixture can be detached and
attached on the top. When attaching on
the top, use screws less than 5mm in
size. Longer screws may cause critical
errors inside the camera.
7
❿
⓭
⓫
⓬
9
7
Stand Fixture Groove :
Use this groove to attach a stand.
Make sure to use the correct-size
screws as shown in the figure on
the right.
1/4˝-20UNC (20 THREAD)
L: 4.5mm±0.2mm (ISO Standard),
or 0.197˝ (ASA Standard)
• A stand is not provided with the camera. When using a stand, please refer to the stand user's manual
as well.
Caution
2.2.3. Bottom
2.2.4. Back
⓮
⓰
⓯
⓱
⓲
⓳
8
Audio Input/Output :
IN : The audio input terminal; connect a sound source such as a mic.
OUT : The audio output terminal; connect a sound receiver such as a speaker.
9
Video Output :
Video output terminal is used to set the focus and other functions when the
camera is installed. (You can optimize your monitor’s screen between NTSC and PAL mode using
the NT/PAL switch.)
Chapter 2. Product Information
❽
• The camera is compatible only with the included video cable.
Caution
❿
RESET Switch :
Use this switch to reset the camera to its factory defaults. When pressing the reset
switch for longer than 5 seconds, the RESET LED starts blinking as the camera resets to the
factory defaults. To reset the camera, please wait at least 1 minute after the camera is turned on.
⓫
Auto Iris Lens Switch :
Select DC or Video depending on your current auto iris lens type.
⓬
RS-485 :
Connect the RS-485 to SRX-100B or SUNGJIN with the plus (+) signal to plus
and minus (-) signal to minus.
•
A 30m or shorter length is recommended for the connection.
Caution
