Disassembly and Reassembly _ 29
Part
Figure
Description
Pump-Drain
Preparation:
•
Disassemble the shutter.
- Refer to the “shutter” disassembly section.
1.
Remove the drain pump by gently prying up the
locking tab on the pump. Then rotate the pump
clockwise until it releases from the sump. Then
pull the pump out.
Caution
Remove all water from the sump assembly
EHIRUHUHPRYLQJWKHSXPS)DLOXUHWRGRVRZLOO
FDXVHWKHZDWHUWREHUHOHDVHGRQWRWKHÀRRU
:
Inspect the “O” ring seal around the drain
pump. If it is damaged in any way, replace the
“O” ring seal.
'LVFRQQHFWWKHWZRGUDLQSXPSFRQQHFWRUV
Sensor-Turbidity
Preparation:
•
Disassemble the shutter.
- Refer to the “shutter” disassembly section.
1. Remove the turbidity sensor connector.
*HQWO\SU\XSWKHWDEVRQWKHWXUELGLW\VHQVRUDQG
pull it out of the sump assembly.
Caution
&DUHIXOO\XVHDÀDWWLSVFUHZGULYHUWRSU\WKHWDEV
on the sensor as the tabs are fragile and can be
damaged easily.
: Inspect the “O” ring seal around the sensor. If
it is damaged in anyway, replace the “O” ring
seal.
ఐ
Reassembly is in the reverse order of the removal.
