Samson 5006-0, Монтаж и эксплуатация

Страница: 26 / 34

Data transfer from Media 6 to memory pen
Status "write only"
Insert the memory pen into the SERIAL
INTERFACE connector.
The LED signals long flashes.
Press key to start the writing process,
the LED is on.
When the LED goes out, remove the
memory pen.
7.2 Communication with PC
Media 6 can also be operated via the
SERIAL INTERFACE from a PC/notebook
using the TROVIS-VIEW Configuration and
Operator Interface.
Refer to the Mounting and Operating
Instructions
EB 9527-2 EN for operation.
8 Troubleshooting
Errors that occur are reported in the upper
part of the LC display with the word
ERROR
and below with an error code, e.g. 16 .
The type of flashing sequence signals the
error code of Media 6 with LED. Thus, error
code
1
is signaled as follows:
long medium 9x short
Refer to the table on page 27 for the de-
scription of the error codes.
Reset or acknowledge errors by pressing
the
key.
Any new error messages then remain sup-
pressed for 8 seconds.
Troubleshooting using the memory pen
If you have a SAMSON memory pen, it can
be used, if necessary, to upload new data
to the instrument within the 8 seconds.
Troubleshooting using a PC or notebook
Communication with a PC or notebook via
the SERIAL INTERFACE functions even in the
error mode.
Hardware errors
These errors are saved in the EEPROM and
reset via the SERIAL INTERFACE after repair
at the manufacturer’s.
Calibration and measuring range error or
error in the tank characteristic
You can only exit the error mode by reset-
ting.
If necessary, new data must first be read
into the device (see section 7.1).
26
EB 9527-1 EN
Troubleshooting