Samson 5006-0, Монтаж и эксплуатация

Страница: 24 / 34

7 Memory pen – communication
7.1 Data transfer using memory pen
The memory pen is a portable data carrier.
Via the SERIAL INTERFACE, it transfers
standardized data which corresponds with
the type of tank and the relevant gas data
to Media 6 instruments on site without re-
quiring a PC or a notebook to be connected.
A label tag can be attached to the memory
pen for identification.
The customized data is transferred to the
memory pen from a PC/notebook using the
TROVIS-VIEW Configuration and Operator
Interface (see
EB 9527-2 EN ) or the data
can be copied from another Media 6 instru-
ment.
The memory pen can be configured to write
and read, only read or only write depend-
ing on the status determined by TROVIS-
VIEW, see table below:
Note!
Memory pens with sets of data or existing
configurations which were created with ear-
lier TROVIS-VIEW software versions (1.02
to 2.20) are not 1:1 compatible with
Media 6 devices with firmware versions
A 2.10 or B 2.10.
They must first be loaded and converted
over TROVIS-VIEW software version (2.30
or higher).
Memory pens must be configured to suit the
Media 6 firmware version.
Media 6 with LCD
Data transfer from Media 6 to memory pen
(write) and from memory pen to Media 6
(read).
Status "write and read"
Insert memory pen into the SERIAL INTER-
FACE connector.
MEMWR
appears at the top of the display.
or has to be pressed
to switch between
MEMWR = Media 6 writes data to
the memory pen and
Memory
pen status
LCD:
indication
LED:
flashing signal
Process
Write and
read MEMWR
or
MEMRD
Long flashes
= writing,
short flashes =
reading
Media 6 writes data to the memory pen or
reads data from the memory pen.
Read only MEMRD Short flashes Media 6 only reads data from the memory
pen.
Write only
MEMWR
Long flashes Media 6 only writes data to the memory pen.
24
EB 9527-1 EN
Memory pen – communication