Revision index : C - 1/29/97
- 17 -
- BF4-1 - B -
Code : RT 6076
27
31
32
36
39
33
38
30
34
35
29
28
37
1 - DISMANTLING
- It is assumed that the spray gun has already been removed.
- Loosen the nozzle nut (39).
- Dismantle the nozzle (33).
- Loosen the screw (36) and remove the contact washer (38).
- Remove the O-ring (30).
- Dismantle the 90
°
powder feed pipe nozzle (28), then remove the O-ring (29).
2 - RE-ASSEMBLY
-
Check condition of the O-rings (29), (30), (31) and (37) and of the brass screw (36). Replace if necessary.
-
Install the O-ring (29). Install the 90
°
powder feed pipe nozzle (28).
-
Install the O-ring (30).
-
Install the brass screw (36) on the contact washer (38). Put the assy inside the gun body (27).
-
Install the nozzle (33) in the nozzle nut (39). Tighten on the gun body (27).
-
Install the gun assy on the HV unit connecting part.
Make sure the O-ring (31), the resistor holder (32) and the O-ring (37) are present.
-
Fasten the gun using the screws (34) and (35).
DISMANTLING AND RE-ASSEMBLY OF THE SRV 028-2 (US) SPRAY GUN
