Revision index : C - 1/29/97
- 11 -
Code : RT 6076
5 - TROUBLESHOOTING
• Powder flow stopped.
• Powder flow impossible,
zero current even with the
trigger pulled.
• The quantity of powder is
insufficient.
• The powder does not adhere
to the parts.
• Incorrect assembly.
• Incorrect spray gun setting.
• Excess generator intensity.
• Incorrect spray gun setting.
• The parts being painted are not
properly connected to the earth.
• The ionizing electrode is covered
with powder.
• The voltage is too low.
• Check that installation and
connections comply with guide
lines in chapters 2 and 3.
• Follow instructions in section 3.2.
• Check rules 3, 4 and 6 in section
2.1.
• Cut power supply, then power up
again.
• Follow instructions in section 3.2.
• Check that the electrical resistance
of the parts, in relation to the earth
is less than 1 M
Ω
.
• Clean the electrode and check that
output current is < 30
µ
A for flat-jet
nozzles.
• Increase the voltage, and make
sure output current is < 30
µ
A/gun
(i.e. 60
µ
A for two guns).
SYMPTOMS
PROBABLE CAUSES
REMEDIES
