SAMES KREMLIN
Page 13
Manual : 573.190.112
SUCTION VALVE (27)
Unscrew the suction valve body (28).
The ball (29) is secured by means of
a stop ring (30).
Reinstall the suction valve assembly
changing the seal (26).
EXHAUST VALVE (33)
Unscrew the cylinder (25).
Unscrew the seat (31) by holding the
valve support (34) to remove the ball
(32).
Check the valve seal (33) condition,
change it if necessary.
Reinstall the parts in the reverse order
of the disassembly sequence and
tighten the seat (31) completely on the
valve support (34). Change cylinder
seal (26).
CARTRIDGE (20)
Disassemble the BASE fluid section
from the motor removing the tie-rods
(1), the pin (3) and the connecting pin
(2).
Take off the circlips (21) located on
the fluid section flange (36) and push
the cartridge (22) downwards to
remove it.
Install a new cartridge (20).
Carry out the disassembly in the
reverse order of the disassembly
sequence. Be careful not to damage
the inner seal when inserting piston
rod (35) into the cartridge (22).
CATALYST FLUID SECTION - HB (refer to Doc. 573.396.050)
SUCTION VALVE
(refer to base fluid section - suction valve)
EXHAUST VALVE
(refer to base fluid section - exhaust valve)
CARTRIDGE
Pull on the cartridge (43) by means of a hook to remove it from the flange (44) of the suction kit.
Install a new assembly. Lubricate the seal (50).
Slide the cartridge (43) on the piston rod (41) and insert it in its housing until the stop.
Be careful not to damage the inner seal when inserting piston-rod into cartridge.