SAMCOM FPBN10A, Руководство пользователя

Страница: 10 / 16

10
Charging Equipment Notes
1. Do not expose the charger to rain or snow.
2. Chargers by severe impact, or has been dropped, or subject to
any damaged, do not use again.
3. Can not disassemble the chargers by severe impact, or has been
dropped, or subject to any damaged.
4. Can not replace the original power cord and plug provided. If
plugs and sockets do not match, please ask the qualified
electrician to install an outlet to avoid electric shock.
5. To avoid damage to the power cord or outlet, holding and pull out
the plug from the wall socket, do not pull the power cord to pull
the plug.
6. To avoid electric shock, pulling out the charger plug from the wall
socket prior to maintenance or cleaning.
7. The use of non proposed or supply attachments may cause
fire, electric shock or personal injury.
8. Take care the power cord location, it should not be trampled, do
not stumble, will not suffer damage or compression.
9. Unless absolutely necessary, do not use extension cords.
Improper use of extension cords can cause fire or electric shock.
If you must use an extension cord, make sure:
to use the same extension cord plug pins.
plug specifications same as the charger plug.
length of 30 meters or less using 18AWG wire, the length of 45
meters or less using 16AWG wire.
10. Can not replace the charger power cord. When the power cord
is damaged, should immediately stop using the charger.
Basic Function
Operation Guide
Buttons, Control Knobs, Switches and Indicators
■ PWR/VOL (power / volume) It is used to turn on or off the power supply,
control knob and to turn up and down the volume.
■ Transmitting indicator When the PTT buttton is pressed, the
indicator turns red, which shows the walkie-
talkie is in transmitting mode.
■ Busy indicator It will turn green when the transceiver is in
monitoring mode and squelch is open.
■
PTT (push-to-talk) button It switches the machine between
transmitting and receiving states.
■ MONI (monitoring) button In receiving state, holding down this button
allows you to monitor the channel. When
the button is pressed, the busy indicator will
turn green.
■
Scan/Call button It is used to start / exit scanning or start
calling.
■ Channel selection knob It is used to select the channel you want to
use.
Power On/Off
Rotate the PWR/VOL control knob clockwise
until a “ka-ta” sound is heard to turn on the
power. When you receive calls, the knob
provides you the ability to change the
volume for your listening habits. When
shutting down the transceiver, you need to
rotate it counterclockwise until a “ka-ta”
sound is heard.
19