SAMCOM FPBN10A, Руководство пользователя

Страница: 13 / 16

3. Place the battery or the transceiver with battery on the charger.
4. Confirm that the battery contacts are well connected with the
charger contacts, and the charge indicator light turns red, which
represent the beginning of the charging operation.
5. After a period of time, when the indicator light turns green, it shows
the completion of the charging operation.
Disassembly and Reassembly
Installation/Removal of the Battery
1. Installation of the Battery
Please make sure the transceiver is
powered off, and then hold down the
belt clip
①
to open it , and insert the
two bumps on the top of the battery
into the aluminum grooves of the
transceiver in the direction of the
arrow
② , and to finish the installation,
press the bottom of the battery in the
direction of the arrow
③ until the “ka-ta”
sound is heard.
Note: If the battery is not fixed well, please remove it and reinstall.
Get Familiar with the transceiver
2. Removal of the battery
To remove the battery, please make
sure the transceiver is powered off,
and then press and hold
①
to
open the belt clip so that the
battery can get out when the
buton
③
has been turned upward.
Pull the battery out according to the
arrow
②
after the battery hook is detached.
(1) PTT Transmitting
(3) Scan/call button
(5) Channel selection knob
(7) Speaker
(9) Status indicator
(11) Earphone cap
(2) MONI (monitor) button
(4) Antenna
(6) Power/volume switch
(8) Microphone
(10) Battery release button
(12) Earphone input
Note: When pulling out, the tilt angle of the battery with the
transceiver can not be too large, so as to avoid heavy wear and
tear between the bump at the top of the battery and the groove at
the top of the main body.
(13) Lifting rope hole
(15) Battery
(17) Charging contacts
(14) Belt clip
(16) Belt screw
13