Operator’s manual
Trailed tedder
P4-471 C P4-531 C P6-771 C
- 25 -
WARNING!
Removing clogs and jams while the tedder is in operation can lead to the
accident!
In case of machine blockage caused by wrapped material, set the machine on a flat surface,
remove excess material using sharp tool. After clearing the machine check if nothing has been
damaged.
To remove any clogging it is obligatory to disconnect the drive and the motor, take out the
ignition key. When eliminating any clogging on the machine, use also safety means for operator, so
protective gloves and tight wear.
WARNING!
Do not let the grass wind around the rotor's shield of the tedder! During work,
if the block-up occur, remove it!
Fig. 22.
Wrapped grass under the gearbox
5.7.
Dismounting tedder
CAUTION:
When dismounting, make sure there is no person in between the tedder and
the tractor.
In order to dismount tedder from tractor perform the following:
turn tractor's engine off and take ignition key off,
support tedder with support leg on an even and stable ground,
dismount PTO shaft from tractor and place it on support,
disconnect hydraulic hoses;
dismount tiller from tractor's beam by taking pin out.
