Instruction manual
Rear - front and rear flail mowers
MIDO, GRINO, VINO, MAMUT, RIO
-
15
-
Fig. 8.
Location of warning labels
NOTE:
Any spare part used for repair of the mower should have all safety labels provided by the
manufacturer.
5.
USE OF MOWER
5.1. Mounting mower on tractor
The mower should be connected to the tractor using the three point hitch as illustrated
in
Fig. 9
. The upper connector (
1
) and the hangers (
3
) of the lower ties of the tractor should be
placed on the bolts (
2
) of the suspension frame of the mower
Machine should be adjusted in such a way that the sliding skid is perpendicular to the ground.
After connecting the mower it should be adjusted on level ground using the upper connector (
1
) and
the hangers (
3
) of the lower ties of the tractor (
Fig. 9
).
After connecting the mower to the tractor check the lengthwise balance and steering ability of
the tractor-mower unit. To do this, calculate to formulas given in the chapter 8 or weigh the set, and
then drive on the scales only with front/rear axis of the tractor (the mower must be in the transport
position, lifted up). If the weight of the front/rear axle of the tractor is at least 20% of the entire
weight of the unit then steering ability has been preserved. If this is not the case the front axle
should be additionally weighed down. The same procedure should be followed when connecting the
mower to the front/rear of the tractor.
N-28
(N-29–540 rpm)
N-162
N-05
N-28
N-29
N-01; N-03; N-04; N-07; N-09
N-14; N-15; N-52; N-106
N-117; N-162; N-167; N-168
N-210; N-233
