Instruction manual
Rear - front and rear flail mowers
MIDO, GRINO, VINO, MAMUT, RIO
-
26
-
7.3. Risks present when lubricating
If risk of splashing is present, make sure to wear protective eyewear with side guards.
When lubricating protect eyes and skin against contact with the substance. Therefore use
adequate protective wear with long sleeves and protective footwear. Also use protective gloves.
In case of a contact with skin, immediately wash the infected area with plenty of water with
soap.
Do not allow the product to contaminate water outlets, water courses and soils.
In case of an unintentional release to the environment plug the leak, limit the spillage, and then
collect the oil with non-flammable absorbent material (e.g. sand).
The product is flammable. In case of fire, use adequate fire-extinguishing means (e.g. foam,
water mist, extinguishing powders). Do not use water jets.
Disposal of the used product must be made according to official regulations. Improper disposal
of the used oil poses danger to the environment.
8.
DEFINING TOTAL WEIGHT, AXIS LOAD, TYRE LOAD CAPACITY
AND MINIMUM LOAD
NOTE:
When mounting the machine on a tractor using front and/or rear 3-point linkage, a maximum
value of permissible load cannot be exceeded – tractor's front axis load must be 20% of the
tractor's overall weight.
Before using the tractor-machine assembly, check whether these conditions are met, while
calculating and weighing the assembly.
For calculations the following data is necessary:
T
[kg] Tractor's overall weight
T
P
[kg] Front axis load on unloaded tractor
T
T
[kg] Rear axis load on unloaded tractor
M
P
[kg] Total weight of machine mounted on front 3-point linkage or weight of front ballast
M
T
[kg] Total weight of machine mounted on rear 3-point linkage or weight of rear ballast
A
[m]
Distance between tractor's front axis center and center of gravity of machine mounted
on front 3-point linkage / front ballast
B
[m] Distance between tractor's axes
C
[m]
Distance between tractor's rear axis center and centers of ball joints on tractor's lower
links
D
[m] Distance between centers of ball joints on tractor's lower links and center of gravity of
machine mounted on rear 3-point linkage / rear ballast
2
3
2
3
1
3
2
3
2
3
2
3
1
3
1
3
1
M
M
T
T
P
T
T
A
B
C
D
