Instruction manual
Rear - front and rear flail mowers
MIDO, GRINO, VINO, MAMUT, RIO
-
20
-
5.8. Dismounting mower from tractor
WARNING:
When dismounting, make sure there is no person in between the machine
and the tractor.
To dismount the mower from the tractor, do the following:
turn the cutter-shaft’s drive off,
place the mower on an even, paved ground, lower and secure support legs, check, if the mower
is properly secured against falling,
turn the tractor's engine off and take ignition key out,
dismount the PTO shaft and place it on a shaft holder,
detach tractor’s top and lower links from the mower’s hitch,
carefully drive away with the vehicle.
6.
MOUNTING AND ADJUSTMENTS
6.1. Setting mowing height in MIDO, GRINO, MAMUT, RIO flail mowers
Please adjust the mowing height according to own needs and in accordance with
Fig. 15
and
Tab. 7
. Mowing height adjustment is possible by changing position of copying shaft. Therefore
undo bolts fastening the copying shaft and re-tighten them on the desired level.
Fig. 15.
Setting the mowing height
Tab. 7.
Possible mowing heights
Position
Mowing heights – A[mm] in mowers:
MIDO
GRINO
MAMUT
RIO
I + 0
21
12
8
10
II + 0
38
31
30
32
III + 0
51,5
49
50
52
IV + 0
62
68
68
70
V + III
21
-
-
-
VI + IV
55
-
-
-
6.2. Setting mowing height in VINO flail mower
In
VINO
flail mower, there is a possibility of set the copying shaft in two main positions
marked by (
0
) and (
1
)
in
Fig. 16
. The default position is
0
position. Depending on the own needs,
there is a possibility of the mowing height adjust by using (
I-VIII
) positions (
Tab. 8
). To changing
the copying shaft height in (
1
) position, holes in the sides of the mower should be made and counter
knives should be demounted. In this position, the copying shaft is cleaned by flail shaft. The rear
plate position should be adjusted to own needs.
