Instruction manual
Rear - front and rear flail mowers
MIDO, GRINO, VINO, MAMUT, RIO
-
23
-
Fig. 19
. a)
Overview of the belt gear in VINO flail mowers;
b)
belt tensioning system in VINO flail mowers
6.4.3. Checking flail blades
IMPORTANT:
Always check the condition of flail knives and flail knife sockets before each
operation. Worn or damaged elements should be considered as hazardous for
life.
If needed replace knives. To keep the shaft well balanced, knives must be of the same type
and weight. In the case of excessive vibrations of the machine, please balance the flail shaft.
After flail knives are replaced, make sure they are installed in a correct position, as in
Fig. 20
.
Knives can be obtained from the manufacturer of the mower – "SaMASZ".
Fig. 20.
Way of assembling the flail knives
Worn flail blade securing bolts should always be replaced. Using bolts with strength rating
lower than 10.9 is forbidden.
6.4.4. Daily maintenance
The following should be done everyday after finishing work:
wash the mower removing any remains of dirt or vegetation,
check all visible external parts and assemblies and their connections,
tighten all loose bolt connections and replace all worn or damaged parts,
lubricate the telescoping shafts of the ATS with an STP grease,
1
a)
2
5
7
8
6
4
3
b)
Spinning
direction
Direction of travel
