Operator’s manual
Double-sided disc mowers
with central suspension
- 29 -
To lift only one cutterbar to any height, push button (12)
, for the right cutterbar and push
button (14)
. The lifted bars may be locked by pushing buttons (14)
and (13)
.
5.2.3.
Starting the conveyer’s belt
To turn on the conveyor belt and start left conveyor (L), press button (7)
until the diode
lights up. Analogically, when button (8)
is pressed, the corresponding diode is lit up, which
starts the right conveyor (R). Turning conveyors off is possible by pressing again the buttons
responsible for turning conveyors on (Fig. 18).
5.3.
Preparing the mower for transport
To prepare the mower for transport and to meet safety precautions, please do the following:
lift the mower with tractor hydraulic lift until the lower lift pins of the mower 3-point
linkage frame raise about 1' 8" above the ground (Fig. 23),
lower the transport height on the tractor links, so it does not exceed 13' 2" (Fig. 23),
lift support legs S and block them with cotter pins (Fig. 20),
before putting the mower in transport position block transport lock (Fig. 21).
NOTICE: Unblocking the lock may cause damage to PTO shaft,
for mower equipped with belt conveyors, if the conveyors are lifted, lower them and block
them with cotter pins,
lift the cutterbar by hydraulic cylinder vertically until the pawl Z locks in (Fig. 15),
secure the cutterbar against falling by activating the shut-off valve (Fig. 22) placed on the
mower’s hydraulic cylinder.
Fig. 20. Support legs
Fig. 21. Transport lock: a) Operating position (mowing), b) Transport position with lifted mower
S
Transport lock
b)
a)
