CAUTION
Inspect the tire to confirm there is no sidewall or major tire damage. Tire sealant will not repair major tire damage, sidewall punctures or
punctures greater than 5mm. Puncturing objects should be remove prior to using this kit. Always use a tire gauge to check the actual pressure
in tires. Do not overinflate the tire.
Repair with tire sealant is a temporary repair when used in passenger’s vehicles. Seek a permanent professional repair. Sealant will remain
liquid, which may result in imbalance or vibration. If vibration occurs, seek an intermediate professional repair.
Sealant removal instructions
Tire sealant is non-flammable and water based so clean up is simple. The sealant should be rinsed or wiped out of the tire prior to making
a permanent repair. Should any sealant fall on the shop floor, simply wipe it up with a rag and rinse off the area with water. If TPMS sensor
present, wipe sensor with damp rag prior to reinstallation. This sealant will not corrode or negatively affect the rim or tire.
Tire sealant
It contains latex, propylene glycol and ammonia (less than 1%). Avoid prolonged inhalation, skin contact and contact with eyes. Eye protection
must be worn during installation. For skin contact, wash thoroughly with soap and water. In the event of eye contact flush with water for at least
15 minutes. Ingestion/Inhalation contact physician immediately and check MDSD.
Consult your local environment protection agency before disposing of any chemicals.
Tire sealant is non-toxic and easily washes away with water.
For inflatables
1.- Select the suitable adapter and insert it into the connector. (Fig. 4). Close thumb latch.
2.- Check our TYPICAL INFLATION PRESSURE chart. This chart is for reference only and you should consult your owner’s manual for a more
exact pressure rating.
3.- Lock it in place and insert adapter into article to be inflated. (Fig. 5)
4.- Plug power cord into cigarette lighter receptacle (Fig. 3). Turn on switch.
5.- When proper pressure is reached, turn off switch, unplug power cord.
6.- Remove adapter from inflated article and remove adapter from connector.
24
Vehicle
ml
Vehicle
ml
473ml
237ml
Recommended sealant values per vehicle
TROUBLE SHOOTING
INFLATOR DOES NOT START / BLOWS FUSES
1.- Push the power plug firmly into the receptacle and twist it back & forth.
2.- Check receptacle and plug terminals for dirt, particularly tobacco. Use a non-conductive probe, not fingers or metal.
3.- Check vehicle lighter fuse. It should be 15 amps’ minimum.
INFLATOR RUNS BUT DOES NOT INFLATE
1.- Be sure the connector always touches the core of the valve stem.
2.- Check article for leaks.
3.- Check hose for breaks and leaks at fittings.
INFLATOR RUNS SLOWLY
1.- Overheated from excessive use. Shut it off and let it cool for 30minutes.
2.- Voltage too low. Check condition of battery
SALKI DC 12V COMPRESSOR
