Configuration with the Service Interface
98-139768-A
Chapter 4: Configuration
4-7
4444
Configuration
The System Function ID is the identification of the SAILOR 6390 Navtex Receiver in the
network. It must consist of the letters CR followed directly by 4 digits. This must be the
same ID that has been set in the SAILOR 6004 Control Panel.
3. Select the antenna type: Low Z (Low impedance) for active antenna or High Z (High
impedance).
4.
Automatic mode
: You can enable automatic filtering of coast stations for each filter
category (Printing device, Storage and display and INS port) within the area of your own
position.
Select the filter (Printing device, Storage and display and INS port) you want to enable.
This can also be set up in the Navtex app in the SAILOR 6004 Control Panel.
5. Enter the receive radius in NM in the last field. Within this radius, relative to own
position, the SAILOR 6390 Navtex Receiver receives Navtex messages from all coast
stations.
You can also select Automatic mode in the Navtex app, see the user manual.
6. Click
Submit
to save the settings in the SAILOR 6390 Navtex Receiver.
Note
Automatic mode requires a valid GPS input and that the coast station
table is maintained (e.g. new coast stations added if necessary).
If GPS fails for more than 10 minutes, a GPS alarm and an Auto mode
alarm will occur. As a consequence, Automatic mode will be disabled
stopping the coast station calculations. All stations are in the list again
and the user can filter out coast stations manually, see the user
manual.
Содержание 6390
Страница 8: ...Table of contents viii 98 139768 A ...