SAIC RTR-4, Руководство оператора, Страница: 33 / 116

RTR-4 Operator’s Manual System Description, Setup, and Quick Start
120300 Rev. D SAIC Proprietary 3-17
7
Insert the WiFi NIC into the PCMCIA slot on the
controller notebook.
8
If 110/220Vac power is to be used for the imager,
connect the supplied Imager external power adapter
directly to a 110/220Vac outlet and connect the
adapter output to the external power connector on the
Imager control panel.
9
If a power-on time delay is desired, use a small
screwdriver to set the desired delay at the time delay
rotary switch on the Imager control panel.
10
Turn on the Imager power switch.
11
Using the key, turn on the X-ray source. Verify that
the X-ray source’s Exposure Selector (display at the
back of the X-ray source handle) is set to 99 pulses.
Do not change this setting during operation of the
RTR-4.
12
If 110/220Vac power is to be used for the controller,
connect the supplied controller external power
adapter directly to a 110/220Vac outlet and connect
the adapter output to the controller.
13
Turn on the controller.
WARNING
When the RTR-4 has been set up and is standing by
for imaging, ensure all personnel follow applicable
X-Ray radiation and RF safety distance
recommendations for field operation. Failure to
comply may result in personnel injury.
STEP ACTION