Sahara SP-1974-A, Инструкция по эксплуатации

Страница: 2 / 21

_ English _
ASSEMBLY OF THE HEATER
Before using the heater, the feet (supplied separately in the
carton), must be fitted to the unit. These are to be attached to
the base of the heater using the 4 self-tapping screws provided,
taking care to ensure that they are located correctly in the
bottom ends of the heater side moldings.
OPERATION
NOTE: It is normal when the heaters are turned on for the first time or when they are turned
on after having not been used for a long period of time to emit some smell and fumes. This
will disappear when the heater has been on a short while.
1.
Choose a suitable location for the heater, taking into account the safety instructions above.
2. Insert the plug of the heater into a suitable socket.
3. Turn the thermostat knob fully in a clockwise direction to the maximum setting.
4. Turn on the heating elements by means of the rocker switches on the side panel. When
the heating elements are on the switches will illuminate. For maximum heat output both
switches should be on.
5. When the desired room temperature has been reached, the thermostat knob should be
turned slowly anti-clockwise until the thermostat is heard to click off and the lights on the
element switches are seen to go out. After this the heater will keep the air temperature in
the room at the set temperature by switching on and off automatically.
6. Convector heater also incorporates an internal fan, which can be switched on
independently of the heating elements.
7. Fan Operation: This is operated by means of the switch with the fan symbol alongside it.
The fan will only operate with the thermostat in the ‘ON’ position and can be used when
the heating elements are ‘ON’ to blow warm air into the room. In warm conditions the fan
can be used with the heating elements ‘OFF’ to blow cool air into the room.
Heat switch
Thermostat
Fan switch