SAGEMCOM Dr. Neuhaus ZDUE-LTE-PLUS-VII, Руководство пользователя

Страница: 19 / 62

Commissioning
ZDUE-LTE-PLUS-VII Page 19 of 62
3.5 Configure the device if required
Basic setting
On delivery The ZDUE-LTE-PLUS-VII is delivered with a predefined factory setting.
Depending on requirements, it must be reconfigured. This is

remotely via an LTE/GPRS connection

locally via the RS-232 interface (if there is no active LTE/GPRS
connection)
possible.
Configuration
options Among other things, the password protection, interface speeds, data formats
and the PIN to be used can be parameterised.
For detailed information on parameterisation, see chapter 7.
3.6 Setting and Unlocking the SIM PIN
Parameterisation
options The PIN can be set as follows:

remotely via an LTE/GPRS connection

locally via the RS-232 interface (if there is no active LTE/GPRS
connection)
PIN-less SIM card In the case of PIN-less SIM cards, the PIN query is bypassed, the radio module
does not wait for the PIN to be entered but attempts to log into the mobile radio
network immediately.
Behaviour with
correct SIM PIN If the PIN function of the SIM card used is activated and the PIN on the SIM
card used matches the parameterised PIN, the device automatically attempts
to log into the mobile radio network.
Behaviour in the
event of an
incorrect SIM PIN If the PIN check fails, it is repeated once. If the repeated PIN check also fails,
the device is blocked for further attempts (PIN-ERROR status), so that
operation with a SIM card with the correct number is also no longer possible.
The status/error LED signals a SIM/PIN error (see chapter 2.4).
After disconnecting and reconnecting the power supply, this state is
maintained. This prevents the SIM card from being blocked after a possible
third failed attempt and can only be unlocked again by using the PUK
(Personal Unblocking Key).
Unlocking the
machine To unlock the ZDUE-LTE-PLUS-VII, a SIM card with deactivated PIN function
must be inserted into the device. After start-up, the device attempts to log into
the mobile network, and the PIN-ERROR status is also reset.
Alternatively, the ERROR status can be reset with the service command for
setting a new PIN (see chapter 9.5). The PIN parameterised in the device is set
at the same time.