Safran MorphoAccess SIGMA Extreme Series, Руководство по установке

Страница: 18 / 79

MorphoAccess® SIGMA Extreme Series - Installation Guide
Identity & Security Section 1 :Introduction
18 This document and the information therein are the property of Safran Identity & Security .
They must not be copied or communicated to a third party without the prior written authorization of Safran
2017_2000024418 - V1
April 2017
Recommendations for terminal implementation
Every installation is unique. Sometimes the issues are well defined and can be handled
in a standard fashion; sometimes the issues are very specific and may not be
immediately recognizable.
Safran Identity & Security
recommends following these steps for a successful installation:

Plan the installation - Choose the type of hardware required, decide if a network is
required, and decide on the location and number of required terminals.

Unpack all items - Unpack all items and check against the packing list.

Install network hardware components - Install the cabling and components needed
to run the system.

Install software - Install the software needed to set up the terminals.

Pre-configure device - Connect the terminals to the Ethernet, supply power to the
terminals, and pre-configure the terminals.

Mount devices - Mount the terminals in their final locations

Power distribution and device hook up - Connect the terminals wiring via the back
panel.

Power-up procedure - Check the power connections, and then start the system
safely. First Boot Assistant screen is displayed, where you can perform fundamental
configuration.