MULTILUBE
INSTALLATION AND MAINTENANCE
HINS4AEN.doc
24.08.2006 Rev. 4A
12 (18)
4 REPLACING THE PUMP ELEMENT
1. Remove the shell, see paragraph 3.1 .
2. Ensure that the reservoir is empty. If there is grease in the reservoir (Figure 33), empty the
reservoir by opening the filling connector (Figures 34 and 35) or the hexagonal plug of the
pump block (Figure 36).
3. Move the rubber seal on the side and open the pump element with 27 mm socket or socket
wrench, Safematic code 11790058 (Figure 37).
4. Remove
the
element.
Note
Install the lengthening piece from the end of the element to the new
element. The lengthening piece is glued to the element, open in vice bench
(Figure 38).
5. Install the new element in its place. Ensure that the rubber seal is installed correctly
according to figure 39.
6. Fasten the shell, see paragraph 3.2 .
Figure 33.
Checking the
reservoir
Figure 34.
Opening the filling
connector
Figure 35.
Opening the filling
connector
Figure 36.
Opening the plug of
the pump block
