WLAN SIP IP Phone
SWSIP-1000 User Manual
www.safecom.cn
5
Copyright © 2006 Safecom Technologies Limited
2 Getting Started
Please check the following before using SWSIP-1000:
o
Package contents
o
How to install and remove the battery
o
How to charge the battery
o
How to turn on/off the device
2.1 Package Contents
You should find the following contents in your SWSIP-1000 package:
o
SWSIP-1000 Wireless IP Phone
o
Standard battery
o
SWSIP-1000 Wireless IP Phone User’s Guide
o
Power Supply (AC adapter)
If any of these items are missing or damaged, please contact your distributor or sales
representative immediately.
2.2 Charge your Phone
Remove the battery cover. Press down
on the silver button and slide the battery
cover with your other hand as shown.
Insert battery as shown. Insert the
bottom of the battery first, and push the
top of the battery into the phone.
Place the battery cover back on as
shown. Then, slide the cover towards
the top until it clicks into place.
To charge your phone, remove the gray
rubber covers on the bottom of the
phone. Plug the included power adapter
into a wall outlet, and plug the other end
into the phone’s power jack as shown
below. The
OK key
on the phone will
turn bright red.
The included battery comes fully
depleted and takes 2 hours to fully
charge. When fully charged, the red
OK
key
will turn off.
Once the phone is fully charged, the
battery provides approximately 3.5
hours of talk time, and 21-22 hours of
standby time. Please remember to
reconnect the phone to its power adapter
when not in use.
