SA-PAM-SAN-Eth
User Manual
S-Access GmbH
Tel: +41 44 700 31 11
Oberhausenstrasse 47
Page
9
of
32
Fax: +41 44 700 31 03
8907 Wettswil a/A
Email:
Switzerland WEB:
www.s-access.ch
4 DESCRIPTION OF THE DEVICE
4.1 Exterior design SAN models
The front panel of the device has 3 LEDs (FXO and FXS has 2 additional LEDs):
4.2 LED
STATUS
LOCAL
informs the user about the status of the local device. The following four statuses are
possible
«blinking red»
informs the user about malfunctioning of the modem’s hardware
and software. In this case, the modem is out of order and should be
submitted to the service center for being repaired.
«red»
informs the user about an urgent alarm. An abruption of the
connection, the correspondence of the signal-to-noise ratio which
does not allow to transmit information and a great number of
errored blocks can cause an urgent alarm. See the “Command
menu” chapter for detail.
«amber»
informs the user about non-urgent alarms. An abruption of
connection over the user’s interface can cause non-urgent alarms.
«green»
absence of alarms. Normal functioning of the device.
REMOTE
(WAN)
This LED indicates the Ethernet traffic on the DSL line
This LED indicates the following statuses:
LINK/ACT
(LAN)
«amber»
Ethernet port receiving data packets
