SA-PAM-SAN-Eth
User Manual
S-Access GmbH
Tel: +41 44 700 31 11
Oberhausenstrasse 47
Page
24
of
32
Fax: +41 44 700 31 03
8907 Wettswil a/A
Email:
Switzerland WEB:
www.s-access.ch
•
[Trap Community] Password which will be set in each event, sending to SNMP management
system. This password are using for identification of messages from a guided units.
Maximum length – 10 symbols
•
[Enable TFTP Server]: Permission/prohibition remote upgrade SW of the modem. TFTP
access has poor protection. We are recommending to enable TFTP-access before upgrade
SW and to prohibit after fulfillment procedure of upgrade SW TFTP Server.
•
[DSL Reboot]: this parameter to enable reloads of modems in the case when modems don’t
translate packets via DSL interface.
•
[Time before Reboot]: time which is necessary for definition of connection’s passivity.
•
[Management VLAN]: enable / disable the VLAN packet support for the management of
modems.
•
VLAN ID: The VLAN-ID for the VLAN modem management support.
•
VLAN Priority: This field defines the VLAN priority. 0 is lowest- and 7 is highest priority. This
value will be inserted to every VLAN packed sent from the Discovery modem to the NMS.
6.4.3 Profile
submenu
Users can save and load up to 4 profiles for different tasks. The Profile 0 is the default profile
during power on. Users have to save all new value of parameters before power off.
6.4.4 Erase
NVRAM
Users can erase the non volatile ram. This function will force some part of the unit to there
factory default values.
6.4.5 Security Auto Lock
During this time the user must set up password for the modem. This is also the time after a
telnet-session will be terminated in case of no terminal action.
6.5 Security management submenu
The security management is using for setting the desired password for the console access.
