SA-PAM-SAN-Eth
User Manual
S-Access GmbH
Tel: +41 44 700 31 11
Oberhausenstrasse 47
Page
23
of
32
Fax: +41 44 700 31 03
8907 Wettswil a/A
Email:
Switzerland WEB:
www.s-access.ch
6.4.2 Ethernet Setup submenu
Configuration Management->EtherNet Setup
1.[Speed]:Auto
2.[Duplex Mode]:Auto
3.[Disable Mac Filter]:No
4.IP Address>>192.168.5.105
5.Subnet Mask>>255.255.255.0
6.Gateway Address>>192.168.5.1
8.NMS IP Address>>192.168.5.32
9.Read Community>>
10.Write Community>>
11.Trap Community>>
12.[Enable TFTP Server]:Yes
13.[DSL Reboot]:No
14.[Time before Reboot]:1min
15.[Management VLAN]:No
16.VLAN ID>>2222
17.Priority>>0
Select item number or ESC to Upper level menu>>
•
[Speed]: In the Speed menu, you can setup the Ethernet speed to the following states:
10M, 100M or Auto
•
[Duplex Mode]: In the Duplex Mode menu you can setup the Ethernet ports to the following
states:Half, Full or Auto
•
[Disable Mac Filter]: prohibition of filtration of received packets from Ethernet-port side.
When you set this parameter as “Yes” - all receiving packets on the Ethernet-port will be
translated through DSL-connection. In most cases modems are using together with Ethernet
Switch, and filtration of packets doing on the ports of the switch. In this case you haven’t
necessity to filter packets again and recommend to set this parameter into “Yes”.
•
[ IP Address ,Subnet Mask, Gateway Address ] - necessary parameters of the modem for
remote management via Telnet and SNMP. These parameters are using only for remote
access to the modem without none influence on the user’s traffic.
•
[ NMS IP Address ] address of the system SNMP management on which are send
messages about appearing events.
•
[Read Community] Password for access to variables for reading through SNMP inquiries.
Maximum length – 10 symbols. [Write Community] Password for access to variables for
reading and writing through SNMP inquiries. Maximum length – 10 symbols.
