Rytan RY256, Руководство оператора

Страница: 6 / 39

6
must flip over both left and right top vise jaws and clamp them in place with the large knurled knobs
located below the painted key clamping knobs.
Make sure your vise jaws are clean (no chips) and as you secure the top vise jaw in the “step” jaw
configuration-be sure to push the back edge of the step top jaw firmly and flat against the stepped face
of the bottom vise jaw when tightening the large knurled located below the painted key clamp knob.
See figure 1 below.
Figure 1
When clamping keys in the “step” jaw be sure to open the jaws ONLY enough to slide the key in place
so it will be clamped against the top vise jaw’s “step”. Opening the vise jaw too wide will allow the
key to pass under the step part of the top jaw and the key will be clamped improperly.
Please see below for more vise jaw information
C) Keys are always gauged with the full-function flip-up key gauges. Never attempt to bottom
shoulder gauge a Medeco key against the vise jaws.
D) Always remember to flip down your key gauges before cutting a key. Failure to do so may damage the
Key gauge and key gauge shaft with the cutter wheel.
E) Your stylus and cutter head should be in the Center cut position. Look down onto the key to be
duplicated and note which cuts are straight or angled cuts. Switch ON your machine and gently
release the carriage and operate the “stick-shift” lever until the stylus is right over the left edge of the
first center cut. Ease up on the carriage and manipulate the carriage controls to make a smooth gentle
cut down the left edge of the
“V” cut in the key and then gently up the right side of the “V” cut in
the key. Cut the entire single “V” cut but do not cut over the top of either edge of the “V” cut you are
duplicating. You may reverse the cut to “clean” it up.
Pull gently back on the carriage when the single cut is completed. Note if there is another center cut on
the key and duplicate it also. Duplicate all center cuts one-at-a-time and cut
ONLY those Center cuts
at this time. Remember-do not cut over the top of the “V” and into another adjacent cut. Duplicate
only one cut at a time.
F) Lock back your carriage. Turn OFF your machine. Rotate the stylus and rotate the cutter head and
lock it in place for left cuts.