28
the key as described. Continue to adjust in very small amounts and make a test key until you are satisfied
with the results.
When the adjustment is complete retighten the two cutter head screws with your 3/16” Allen Hex Wrench-
do not over-tighten these screws. Moderate pressure will be sufficient. NOTE: over-tightening of these
two screws may accelerate the rate at which the cutter shaft’s ball bearings wear out.
Reinstall the cutter guard.
22.
Carriage Overtravel Depth Adjustment
Your key machine is equipped with a depth overtravel device. Its adjustment is important. The overtravel
device prevents the cutter wheel from cutting into the vise jaws when there are no keys clamped in the
machine. Stetting the depth overtravel device too high will prevent deep cuts from being made-they will
not get cut all the way down onto the key blank. To adjust the depth overtravel you will need:
•
Slot Head Screwdriver
•
7/16” Wrench
•
Three Pieces of Writing Paper-cut to approximately 1” x 4” each.
Close both vise jaws without keys in them. Release the carriage and position it so the stylus and cutter
wheel are in about the middle of the vise jaws.
Loosen the 7/16” Hex Jam Nut on the front of the carriage. See figure 27.
Loosen the ¼”-20 slotted screw stud with your screwdriver. About 1 turn should be enough. Observe
that the stylus is touching the face of the closed vise jaw.
Gently turn the slotted screw stud with your screwdriver in the clockwise direction and stop when you
feel the stud contact the key machine’s main housing. There is a 3” long hardened roll pin in the
machine’s main housing that the slotted screw stud will contact.
Turn the slotted screw stud an additional ¼ turn after contacting the roll pin the machine’s main
housing. The thread pitch is 20 which is approximately 12 thousandth of an inch per ¼ turn. Tighten
the 7/16” Hex Jam Nut on the slotted screw stud- use moderate tightness.
After tightening the 7/16” nut check the gap between the stylus and the face of the closed vise jaws.
Use three pieces of 1” x 4” writing paper you made earlier. They equal a combined thickness of about
9 thousandths of an inch. Readjust if necessary.
IMPORTANT:
carriage overtravel works only when adjusted properly. The following things can
happen if the adjustment is not done properly.
a) If adjusted to low your cutter wheel may cut into the right-hand vise jaw.
b) If adjusted to high your cutter wheel may not cut deep enough when cutting deep cuts in keys.
c) Carriage overtravel will not prevent cutting the right-hand top vise jaw if the top vise jaw has
come loose and has moved forward into the cutter. PLEASE… check the tightness of the
knurled knobs located right below the key clamping knobs OFTEN.
Содержание RY256
Страница 2: ...2...