Ryobi GD200B, Руководство оператора

Страница: 46 / 160

46 - English
Program
Console
Door
PROGRAMMING THE CAR REMOTES
See Figures 75 and 76.
WARNING:
Keep moving door in sight when using car remotes.
Contact with moving door can cause DEATH or serious
injury.
Once you begin programming the car remotes, you have two
minutes to complete each step. If a step is not completed
within two minutes, programming information will be erased.

Press the PROGRAM button on the garage door opener’s
console.
 The main garage door opener’s LEDs will turn off and the
PROGRAM
button will flash three times.

Select button 1 or 2 on the car remote. Press the button
once.
 The car remote’s green LED will flash.

The PROGRAM button on the main unit will flash three
times.
 The garage door opener main unit LEDs will turn on.

To verify that the program is set, press the car remote
button you selected earlier.
 The garage door will open or close.

Repeat this process to sync the garage door opener with
an additional remote.
NOTE:
Buttons
1
and
2
cannot both be programmed to the
same garage door opener.
NOTE: Safety sensors must always be connected properly
for the door to operate from the car remote.
NOTE:
The garage door opener cannot be operated with a
car remote until travel limits have been set.
Fig. 76
Car
Remote
Visor
Clip
Buttons
Fig. 75
OPERATION