RWD D180P, Руководство пользователя

Страница: 13 / 38

corresponding hanging piece of the vertical plate, and the position can be
adjusted as needed. Pull the horizontal shelf bracket forward so that its
front hole engages with the corresponding front hanging piece of the side
vertical plate.
4) Ejector rob assembly. Find three ejector robs, springs and end covers from
the accessory kit (2 pieces for the rear part of inner container and 1 piece
for the upper front part of inner container). Insert spring ends from ridges
into ejector robs and press the springs against the opposite side of the
ejector robs. Spring will then be inserted into place after a cracking sound.
Slide the end covers into ejector rods from above the springs. Insert one
end of ejector rod into the corresponding hole of the vertical plate, and then
the installation is completed.
Note: To install an ejector rod assembly, do not install the assembly to the lower
edge of incubator near the humidity pan, or otherwise the pan may not be easily
replaced.
3.1.5 Install the horizontal shelve
Install the horizontal shelf into corresponding bracket for horizontal shelf as
shown below.
Vertical plate
Horizontal shelf bracket
End cover
Spring
Ejector rod
The opening of horizontal
shelf is facing down
Hanging slot