SPEED CONTROL
• Turn the speed control clockwise to the speed you want.
• Turning the speed control anti-clockwise to ‘
P
’ will give you a pulse at high speed.
• Turn the speed control back to “
0
” to turn the motor off.
CAUTION: Do not run the motor continuously for more than 10 minutes, it may
overheat. After 10 minutes, switch off for at least 10 minutes to let the motor cool.
PULSE FUNCTION (‘P’)
• Turning the speed control anti-clockwise to ‘
P
’ will give you a short burst at high speed.
• Use ‘
P
’ as a “pulse” function, for greater control over the mixing process.
ADDING INGREDIENTS
If you need to add ingredients after you have started blending:
Turn the speed control to “
0
” (off position)
Wait until the blades stop moving.
Remove the lid.
Add the ingredients.
Replace the lid.
Start the motor.
Caution: Check that the added ingredients do not push the volume over the MAX
mark.
POWER DOWN
Turn the speed control to ‘
0
’ (off position) and wait until the blades stop moving
before removing the lid from the jug or removing the jug from the motor unit.
To remove the jug, turn it clockwise until the spout points along the head of the Pro-
Mix.
Lift the jug off the drive.
HOT LIQUIDS
Caution: Pouring hot liquids into a cold blender jug could cause the jug to break.
Before pouring into the jug, let the liquid cool down to a temperature you can
comfortably handle – i.e. keep the liquid temperature below 40°C.
THE BLADE UNIT
REMOVING THE BLADE UNIT
Remove the lid and turn the jug upside down.
Use the grips to turn the blade unit anti-clockwise to release the latches on the blade
unit from the tabs on the inside of the jug.
Lift the blade unit out of the jug.
Caution:
The cutting blades are very sharp. Handle the blade unit with extreme
care and caution.
10
FITTING THE BLADE UNIT
Lower the blade unit into the upturned jug.
Use the grips to turn the blade unit clockwise to engage the latches on the blade
unit with the tabs on the inside of the jug.
Содержание Pro-Mix RHSB032
Страница 66: ......
