RUPTELA Trace5, Руководство пользователя

Страница: 37 / 44

36
1.5 Trace5 Installation in Vehicle
Installation Using OBDII Harness
Installation Method
To install the device, you need to connect it to a power supply and an ignition source. They may be found
in the following locations:
· The OBD diagnostic port
· The fuse box
· The 9-Pin Deutsch port
Required Tools
Before starting the installation, make sure you have the following tools:
· A panel removing tool
· A wrench
· Zip-ties or double-sided tape
· Crimp terminals
Installation Recommendations
Make sure the installation is carried out only by qualified personnel!
Before starting the installation, decide where you will install the device. The installation location depends
on the vehicle and the location of the OBD2 socket. Follow these recommendations to ensure that the
device works properly:
· Install the device in a service access area (under the dashboard, behind the fuse box, etc.) as
close to the top of the dashboard as possible
· Fix the device firmly to the attaching surface, make sure it does not move or shake
· Avoid installing the device near metal surfaces or cables
· Do not install the device near heat emitting or moving parts
· Install the device with an angle of up to 45° in any axis
· The device must be facing towards the sky (see the picture below)
· Make sure that the device is connected to the power supply and to the ignition source set in
the Device Center engine detection if the ignition is to be captured via DIN