Runxin 53515, Руководство пользователя

Страница: 47 / 60

MODEL 53515/53615/63515/63615/73515/73615
43
valve but power failure
while salting.
E. Brine refill is out of
control.
F. Ball valve doesn’t close.
E. Repair or replace safety brine
valve.
F. Replace ball valve.
7. Pressure
lost or rust in
pipeline
A. Iron in the water supply
pipe.
B. Iron mass in the softener.
C. Fouled resin bed
D. Too much iron in the raw
water.
A. Clean the water supply pipe.
B. Clean valve and add resin
cleaning chemical, increase
frequency of regeneration.
C. Check backwash, brine draw
and brine tank refill. Increase
frequency of regeneration and
backwash time.
D. Iron removal equipment is
required to install before softening.
8. Loss of
mineral
through drain
line.
A. Air in water system.
B. Strainer broken.
C. Improperly sized drain
line control..
A. Assure that well system has
proper air eliminator control.
B. Replace new bottom strainer.
C. Check for proper drain rate.
9. Control
cycle
continuously.
A. Locating signal wring
breakdown.
B. Controller is faulty.
C. Foreign material stuck
the driving gear.
D. Time of regeneration
steps were set to zero.
A. Check and connect locating
signal wiring.
B. Replace controller.
C. Take out foreign material.
D. Check and reset program
setting.
10. Drain
flows
continuously.
A. Internal valve leak.
B. Power off when in
backwash or fast rinse.
A. Check and repair valve body or
replace it.
B. Adjust valve to service position
or turn off bypass valve and restart
when electricity supply.
11.
Interrupted or
irregular
brine.
A. Water pressure is too low
or not stable.
B. Injector is plugged or
faulty.
C. Air in resin tank.
D. Floccules in resin tank
A. Increase water pressure.
B. Clean or replace injector.
C. Check and find the reason.
D. Clean the floccules in resin tank.