Runxin 53515, Руководство пользователя

Страница: 46 / 60

MODEL 53515/53615/63515/63615/73515/73615
42
3. Softener
supply hard
water.
A. Bypass valve is open or
leaking.
B. No salt in brine tank.
C. Injector is plugged.
D. Insufficient water flows
into brine tank.
E. Internal valve leaks.
F. Incorrect regeneration
time or raw water quality
deterioration.
G. Shortage of resin.
H. Bad quality of raw water
or turbine is blocked.
A. Close or repair bypass valve.
B. Add salt to brine tank and
maintain salt level above water
level.
C. Change or clean injector.
D. Check brine tank refill time.
E. Change valve body.
F. Set correct regeneration time or
water capacity treatment.
G. Add resin to mineral tank and
check whether resin leaks..
H. Reduce the inlet turbidity, clean
or replace turbine.
4. Softener
fails to draw
brine.
A. Inlet line pressure is too
low.
B. Brine line is plugged.
C. Brine line is leaking.
D. Injector is plugged or
broken down..
E. Internal valve leaks.
F. Drain line is plugged.
G. Sizes of injector and
DLFC are not matched with
tank.
H. Ball valve or cable
breaks down.
A. Increase inlet line pressure.
B. Clean brine line.
C. Replace brine line.
D. Clean or replace new injector.
E. Replace valve body.
F. Clean drain line flow control.
G. Select correct injector size and
DLFC according to the instruction
manual.
H. Replace ball valve or cable.
5. Unit used
too much
salt.
A. Improper salt setting.
B. Excessive water in brine
tank.
A. Check salt usage and salt
setting.
B. See problem no.6.
6. Excessive
water in brine
tank.
A. Overlong refilling time.
B. Remain too much water
after brine.
C. Foreign material in
brine valve.
D. Not install safety brine
A. Reset correct brine refilling time.
B. Check the injector and make
sure no stuff in the brine pipe.
C. Clean brine valve and brine line.
D. Stop water supplying and restart
or install safety brine valve in salt
tank.