Ruijie RG-S8600E Series, Быстрая инструкция по установке

Страница: 38 / 41

·
4.11 Connecting the Power Cord
Connect the power cord to the location as required according to the identification on the AC power module panel, including
RG-PA1600I, RG-PA600I, RG-PA1600I-P, RG-PA1600I-PL and RG-PA3000I-PL.
Make sure the socket is powered off before the power cord is connected.

Connect the AC power cord
1) Insert the AC power plug into the power module socket.
2) Take out the anti-loose buckle.
3) Install the anti-loose buckle on the front panel of the power module
4) Fasten the anti-loose buckle to the power cord.
5) Connect the other end of the power cord to an external power socket.
Figure 4-42 Connecting the Power Cord
Please use the 3-pin power cord. The cross-sectional area of each pin is 1.5 mm
2
or 14 AWG minimum.
16A and 10A power cords are available for the RG-S8605E, RG-S8607E, RG-S8610E and RG-S8612E AC power supply. Adopt
the proper socket and verify the AC power supply capacity in the machine room.

Connect the power cord to the DC power module ( RG-PD1600I or RG-PD600I. ) as required according to the identification on the
module panel.
1. Take out the DC power module and power cord. Insert the DC power into the power module slot.
2. Remove the screws on the grounding terminal of the DC power supply with the screwdriver.
3. Connect the DC power cords according to the instructions on the panel, which are green with yellow strip(ground wire), blue(-)
and red(+) from left to right, as shown in the following figure.
4. Fasten the OT terminal of the DC power cord to the connecting terminal with the screwdriver.
Figure 4-43 Power Cord Instruction on Chassis