Hardware Installation and Reference Guide
Installing the Switch
30
Pull out the expansion module straightly and slowly.
Do not hold the edge of the PCB or crash the components on the PCB.
Install a filler panel in a vacant slot where an expansion module is removed to ensure normal ventilation and
dissipation and avoid dust in the chassis.
3.5 Installing and Removing the Power Supply Module
Wear anti-static gloves before the following operations.
Installing an RG-PA150I-F/RG-PA150IB-F M odule
Step 1: Take out a new power supply module and ensure that the input mode and input indicators of the power supply
module meet requirements.
Step 2: Remove the filler panel. With the panel printed with the power nameplate information as the upper panel, grab
the power supply module handle with one hand and hold the bottom of the power supply module with the other hand.
Straightly and slowly insert the power supply module into the chassis along the guide rail until it clicks into place.
Figure 3-5 Installing a Power Supply Module
Insert the power supply module straightly and slowly. Please pay attention to the direction of the power panel to
avoid wrong insertion.
Insert the power supply module into the chassis gently. If it is difficult to push it, pull out the power supply module and
check whether it is aligned with the power supply module slot. If yes, proceed with the operation.
Removing an RG-PA150I-F/RG-PA150IB-F M odule
