Cutting Centre SR 2 BiTurbo
5
Wear protective clothing according to EN ISO
13688, EN ISO 17491!
(e.g. appropriate coats / overalls)
[The information on the proposed personal protective equip-
ment has only an advisory function. A full risk assessment
should be carried out before using the product to assess
whether the indicated personal protective equipment is
suitable for local conditions. Personal protective equipment
should conform to the relevant EU standards.]
!!! The operator must operate the machine according to the intended
use and strictly observe all points listed in the
“Operation”
work in-
structions prepared by the supervisor.
!!! Before putting the machine into operation for the first time and on
each working day, the operator must check the functionality of the
following safety devices:
a)
Visual check for changes or damages on all machine sides
and accessible machine parts, e.g. the cut-off knife. The ma-
chine must be shut down in the event of any damage or
changes!
b)
Check the safety switches as follows:
Install upper belt section and transport belt, insert protective
guard, close the knife protection box, insert the slider and
close the funnel with it.
•
Start the machine.
–
Open knife protection box 20 mm
wide.
–
If the machine does not switched off, it must be
shut down immediately!
•
Start the machine.
–
Open the slider of the funnel 20 mm
wide.
–
If the machine does not switched off, it must be
shut down immediately!
•
Open the knife protection box.
–
Dismantle the transport
belt and upper belt section.
–
Close the knife protection
box.
–
Start the machine.
–
If it should start, it must be shut
down immediately!
•
Remove the grate frame.
–
Insert the slider.
–
Start the ma-
chine.
–
If it should start, it must be shut down immedi-
ately!
