Ruckus Wireless ZoneFlex 7761-CM, Руководство по установке

Страница: 43 / 78

37
Hardware Features
LEDs
CM Boot Sequence
a. All LEDs blink for a few seconds.
b. White stays solid on.
c. Red, yellow, middle green and blue blink in sequence.
d. Red, yellow and middle green blink together for a few seconds.
e. Blue goes solid when the link to the AP is established.
f. Red LED flashes as CM tries to acquire downstream.
Red goes solid when downstream is acquired.
Blue flashes to indicate communication across the AP link.
g. Yellow LED then comes on solid when upstream acquired.
h. Middle Green on indicates cable modem on-line successfully.
CM Online/Steady State
• White on indicates CM mode.
• Red, yellow, middle green and blue LEDs are on.
The LEDs now alternate between CM and AP modes.
LEDs in Access Point Mode
In the Access Point (AP) mode, the far-right Green LED is lit.
NOTE: The LEDs also do not indicate whether the AP is in standalone mode or if
ZoneDirector is managing the AP. To check if ZoneDirector is managing the access point,
log into the ZoneDirector Web interface, go to the
Access Points page, and then search
for the access point’s MAC address. If you are unable to find the access point, then it is
very likely in standalone mode. If you have multiple ZoneDirector devices on the network,
make sure you check each one of them.
For Cable Operators, APs will typically be in ZoneDirector mode after initial boot. If the
AP is unable to reach the ZoneDirector on initial boot, it remains in standalone mode.
White Solid On
far-right Green Solid Off
Table 8. LED behavior in CM mode
LED Color State Meaning