RTRMAX RTH150, Оригинальное руководство пользователя

Страница: 6 / 25

Проверил: Р.Ч./24.03.2015г
same time the reduction of the necessary advancing force makes fatigue-free working possible.
The adjustment lever makes possible the adjustment of the pendulum action in four steps. The
switching can take place with the machine running.
Step 0:
No pendulum action
Step 1:
Small pendulum action
Step 2:
Medium pendulum action
Step 3:
Large pendulum action
The following basic recommendations are to be observed:

The finer and cleaner the cut edge should be, the smaller the pendulum step selected
should be or switch off.

Fort he working of thin metal such as sheet metal, switch off the pendulum action.

In materials such as softwood and cutting in the direction of the grain, the maximum
pendulum action can be used.
OPERATING INFORMATION
CUTTING
Do not depress too much to worpiece for avoiding damaging and heating of blade. For avoiding
vibration and cutting beter, put the workpiece to a firm plate.
CUTTING ANGLE ADJUSTMENT
For cutting of mitre angles loosen the 2 set screws till the saw shoe to the required mitre angle.
Mitre angle to the left/right is maximum 45°. After adjusting desired angle, tighten the set screws
firmly. Adjustable angles on jigsaw are 0°, 15°, 30°, 45°.
PLUNGE SAWING
Only soft materials such as wood, aerated concrete, plaster board aerated concrete, plaster board,
etc. may be worked with plunge method.
Cut-outs in wood are possible without predrilling by piercing with the running machine. This is
requires a certain amount of practice, however, and is possible only wit short saw blades.