RTD Embedded Technologies, Inc.
|
www.rtd.com
46
LAN35MH08HR & LAN35ME08HR User’s Manual
location SSH network connection
!
line vty 7
exec-timeout 15 0
location SSH network connection
!
line vty 8
exec-timeout 15 0
location SSH network connection
!
line vty 9
exec-timeout 15 0
location SSH network connection
!
line vty 10
exec-timeout 15 0
location SSH network connection
-- more --, next page: Space, continue: g, quit: ^C
<Space>
!
line vty 11
exec-timeout 15 0
location SSH network connection
!
line vty 12
exec-timeout 15 0
location SSH network connection
!
line vty 13
exec-timeout 15 0
location SSH network connection
!
line vty 14
exec-timeout 15 0
location SSH network connection
!
line vty 15
exec-timeout 15 0
location SSH network connection
!
end
RTD-SWITCH#
6.4
ICLI Configuration Command Negation
After running a configuration command, one may choose to remove that configuration. The ICLI allows you to negate a command by prefixing it
with no. The following
demonstrates how to use negation to unset the switch’s host
name.
RTD-SWITCH#
configure terminal<Enter>
RTD-SWITCH(config)#
no hostname<Enter>
(config)# end
<Enter>
#
6.5
CEServices Physical Interface Mapping
Each port of the managed switch is identified in CEServices as an
interface
. Interfaces names follow the convention
InterfaceType
SwitchNumber/PortNumber
. (Since each LAN35Mx08 switch operates independently,
SwitchNumber
is always 1.) The mapping of physical
Ethernet ports to CEServices interfaces is as follows:
•
Port 1 = GigabitEthernet 1/1
•
Port 2 = GigabitEthernet 1/2
•
Port 3 = GigabitEthernet 1/3
•
Port 4 = GigabitEthernet 1/4
•
Port 5 = GigabitEthernet 1/5
•
Port 6 = GigabitEthernet 1/6
