RTD Embedded Technologies, Inc.
|
www.rtd.com
48
LAN35MH08HR & LAN35ME08HR User’s Manual
(config-if)#
?
access-list Access list
aggregation Create an aggregation
do To run exec commands in config mode
dot1x IEEE Standard for port-based Network Access Control
duplex Interface duplex
end Go back to EXEC mode
evc Ethernet Virtual Connections
excessive-restart Restart backoff algorithm after 16 collisions (No
excessive-restart means discard frame after 16
collisions)
exit Exit from current mode
flowcontrol Traffic flow control.
frame-length-check Drop frames with mismath between EtherType/Length
field and actually payload size.
green-ethernet Green ethernet (Power reduction)
gvrp Enable GVRP on port(s)
help Description of the interactive help system
ip Internet Protocol
ipv6 IPv6 configuration commands
lacp Enable LACP on this interface
link-oam Enable or Disable(when the no keyword is entered)
Link OAM on the interface
-- more --, next page: Space, continue: g, quit: ^C
<Space>
lldp LLDP configurations.
loop-protect Loop protection configuration on port
mac MAC keyword
media-type Media type.
mtu Maximum transmission unit
mvr Multicast VLAN Registration configuration
network-clock network-clock
no Negate a command or set its defaults
port-security Enable/disable port security per interface.
ptp Precision time Protocol (1588)
pvlan Private VLAN
qos Quality of Service
rmon Configure Remote Monitoring on an interface
sflow Statistics flow.
shutdown Shutdown of the interface.
snmp-server Set SNMP server's configurations
spanning-tree Spanning Tree protocol
speed Configures interface speed. If you use 10, 100, or
1000 keywords with the auto keyword the port will
only advertise the specified speeds.
switchport Switching mode characteristics
thermal-protect Thermal group for the interface.
(config-if)#
end<Enter>
#
Some common interface configuration settings which may be applied (not an exhaustive list):
•
Setting port speed and duplex (using the
speed
and
duplex
commands).
•
Disabling/enabling the interface (using the
shutdown
or
no shutdown
command).
•
Assigning a VLAN for access (using the
switchport access vlan
command).
•
Configuring a VLAN trunk (using the
switchport trunk
command).
It is not possible to directly configure one of the physical ports with an IP address, as all physical ports on the LAN35x08 are Layer 2 interfaces.
To set an IP address, one should create a VLAN interface and set an IP address there, then assign one or more physical interfaces to the newly-
created VLAN. By default, all ports are part of VLAN 1, which already exists in factory default configuration. Refer to the following sections for
details.
