rtd cpuModule CME37786HX, Руководство пользователя

Страница: 105 / 122

CME37786HX RTD Embedded Technologies, Inc.
97
• Apply power to the cpuModule and run Setup.
• Set SSD socket 1 or 2 to the appropriate EPROM or Flash type.
• Set SSD Window to a value which will not conflict with other hardware or software.
• Save your changes and exit Setup.
• Boot the cpuModule.
After booting, the Solid State Disk will be seen by the system as a write-protected floppy. DOS com-
mands normally used to read floppy disks will work with the SSD.
Directly Accessing the Solid State Disk
If you wish to directly access the Solid State Disk of the cpuModule contact the factory for additional
information on doing so.
NOTE! The memory window selected for DOC must not be used
by any other program or hardware device. Make sure this
window is not in use by EMM386 or another memory
manager, or an Ethernet card, PCMCIA card, etc.