RSP M8307-1, Руководство по эксплуатации продукта

Страница: 44 / 60

44 M8307-1 version 2.4
5.10 Hints
5.10.1 Changing tilting angle
The tilting angle of the dust cover mounted on the pneumatic tilting clamp is seamlessly
adjustable within 10°
–135° using the adjustment screw. The default tilting angle is 135°. Set up
of maximum tilting angle is performed in the following way:
Action Note
1 Air off! WARNING! Only perform work on the
pneumatic tilting clamp when the air
pressure is safely switched off.
2 Open position Bring arm of the pneumatic tilting
clamp to open position. Circuit
diagram is found in section 2.4.6.
3 Read angle Read the pre-adjusted angle at the
scale.
4 Release tilting clamp for
adjustment Remove securing
screw “A” in the
cylinder bottom.
5 Set new tilting angle Turn adjustment
screw “B” with until
desired angle has been reached,
adjusting range 10°-135° (APH2 max
105), see scale at the housing.
6 Lock tilting clamp for
adjustment Remount securing
screw “A” in the
cylinder bottom.
5.10.2 Safety
WARNING! The pneumatic tilting clamp is not designed as a complete tool ready
for independent applications and has not been supplied with safety features. Only
when correctly installed, as a part of a production system and with a
corresponding safety control system added, all safety requirements will be met.
Should any faults occur that place personnel at risk, the pneumatic tilting clamp
shall be switched off immediately. Maintenance measures shall only be
undertaken when the machine is at a complete standstill and by qualified
specialists. After maintenance has been carried out, protection devices shall be
refitted in the correct way.
5.10.3 Use of tool-in-stand sensor
The passive tool-in-stand sensor (P8369) mounted on the tool parking
system can, in combination with the active sensor (I1171) on the tool
side, be used to check that the tool/tool attachment is present in the
parking position before the tool changer is permitted to open.
NOTE! Tool-in-stand sensor P8369 should be used
together with safety signal modules P7501-xxx.