Royal Prestige FP6000CT, Инструкция по использованию и уходу

Страница: 18 / 22

5
Remove sanitary plastic wrap from the new
Filter Cartridge. Thread new Cartridge
clockwise onto Lid until you feel resistance.
Make an additional quarter turn.
dO NOT
over-tighten
6 Make certain Gasket is firmly seated onto
Lid.
With new Cartridge connected to Lid,
lower Cartridge into Housing and align Lid
with Housing.
7 Place Clamp around Lid and Housing. Push
Knob forward to latch T-Bolt. Tighten Knob.
8
Push the Blue Tube end into Blue “Outlet”
Collar located on Lid. Push the Red Tube end
into Red “Inlet” Collar located on Lid. Tug
both Tubes lightly to insure they are securely
in place. Re-position System under sink.
9 Remove Battery Shuttle from Monitor and
discard. Insert new Battery Shuttle.
10 Slowly turn cold water supply “ON” and turn
the Lever on Dedicated Drinking Water Faucet
downward. Water will begin filling the System.
Upon initial startup, the Monitored Beauty
Ring will begin blinking GREEN, YELLOW
and RED five (5) times before continuing to
blink GREEN, indicating peak operational
performance. Check that all hose, clamp and
housing connections are tight and do not leak.
11
When using your System for the first time, or
whenever a new Cartridge is installed, allow
the System to flush into the sink for fifteen
(15) minutes. This will expel trapped air and
condition Filter Cartridge for normal use.
(This water may be used to water your plants.)
16
fReSCaPURe
™
ONly ReMOVe bATTeRy shuTTle
AT TIMe Of cARTRIdGe RePlAceMeNT Removing
Battery Shuttle prematurely may result in a loss of
stored data. a new Battery and Battery Shuttle is
included with every Genuine, WQa Certified, Royal
Prestige filter Cartridge.
IMPORTANT
5
7
8
9
6b
Gasket
6a
10
Red Blue
Monitor