Royal Prestige FP6000CT, Инструкция по использованию и уходу

Страница: 15 / 22

fReSCaPURe
™
13
sysTem insTallaTion:
Read these instructions completely before starting system Installation
Make a determination whether you will be able to make a “Typical” installation
(as shown in the illustration on page 10) after looking at your under-sink
cabinet area.
If the configuration of your under-sink area does not permit a “Typical”
installation, it will be necessary to develop one of your own. Be sure to
take into consideration where the System will be permanently located in
relationship to the cold water supply line and Dedicated Drinking Water Faucet.
Make generous allowances for estimating the Tubing lengths required to
make these connections.
(Two Velcro Strips have been provided should you
decide to mount the Monitor to the cabinet wall.)
1
Before starting this installation, be certain to
turn “OFF” the cold water supply located under
your sink. If a shut-off valve is not located on
the cold water supply line, shut off the main
water supply to your home.
2 Locate an area under sink to place the Base.
The Base should be located directly under
the area where the Dedicated Drinking Water
Faucet is installed.
3
Locate the shut-off valve on the existing cold
water supply line. Using a 5/8” open ended
wrench, unthread compression nut located
on top of the shut-off valve by turning the
wrench counterclockwise.
4 Thread the T-Valve onto shut-off valve using
a 3/4” wrench to tighten, then thread
compression nut onto T-Valve using 5/8”
wrench to tighten
(clockwise) .
5
Before pushing the White Tubing (which is
attached to the Dedicated Drinking Water
Faucet)
into the “Outlet” Collar located on
T-Valve, determine whether it is necessary
to shorten Tubing. If so, shorten to desired
length before inserting.
4
3
5
WARNING
Do not use copper tubing with the Collars installed on this System.
although it may appear that copper tubing will fit, water leaks will develop over time.
If copper tubing is required, you must use copper compression fittings that must be
purchased separately and adapted accordingly.