11
To access the Battery Shuttle, slide Battery
Cover upward and set on counter. Remove
old Battery Shuttle from Monitor and discard.
Insert new Battery Shuttle and re-install the
Battery Cover.
12
Orient Tubing and Monitor Cable in Enclosure
so that the Filter Housing can be lowered
into the Enclosure without interference.
13
As you lower the Filter Housing into the
Enclosure, be certain to orient the Knob
towards the back of the Enclosure.
14
Push the Blue Tubing end into Blue “Outlet”
Collar located on Lid. Push the Red Tubing
end into Red “Inlet” Collar located on Lid.
Tug both Tubes lightly to insure they are
securely in place.
15
Tuck the Monitor Cable inside the Enclosure.
Hinge Cover to front of Enclosure as shown,
then press rear portion of Cover into place.
Position the System next to your sink.
16
Slowly turn the cold water “ON” and turn
the Lever on Diverter Valve “UPWARD”.
Water will begin filling the System. Upon
initial start-up, the Display will begin blinking
GREEN, YELLOW and RED five (5) times
before continuing to blink GREEN, indicating
peak operational performance. Check that
all hose, clamp and housing connections are
tight and do not leak.
17
When using your System for the first time,
or whenever a new Cartridge is installed,
allow the System to flush into the sink for
fifteen (15) minutes. This will expel trapped
air and condition the Filter Cartridge for
normal use.
(This water may be used to water
your plants.)
8
fReSCaPURe
™
11a
15a
15b
11b
14
16
12
13
Battery
Cover
Содержание FP6000CT
Страница 19: ...FRESCAPURE 17 Notes...