Roughneck Jackman Fusion Equipment, Руководство оператора

Страница: 33 / 52

JACKMAN FUSION EQUIP – ELECTROFUSION PROCESSOR OPERATORS MANUAL - REV 0
Page 31 of 48
If errors are encountered during the fusion process, the SMART Scanner™ will alert the operator by
showing the following message:
ERROR RECEIVED
Check Processor!
At this point, you should consult the display of the processor for the specific error code and take
appropriate corrective action based on the information displayed.
GPS Mode
Operating the SMART Scanner™ in GPS Mode is the same as operating the SMART Scanner™ in Smart
Scan Mode with the addition of GPS data. For this reason, only the differences are highlighted in this
section.
When the SMART Scanner™ prompts the operator to connect the fitting, the current GPS position will
be displayed after the satellites have been acquired. The screen will look something like this:
CONNECT FITTING 8-1
39.65664N-75.7767W
The display shows the current latitude and longitude as well as the number of satellites that the
SMART Scanner™ is currently tracking and the Position Error Indicator. The SMART Scanner™ can only
accurately report the current position when it is tracking more than 5 satellites. The example above
shows that it is tracking 8 satellites, the level of signal confidence is 1 and the current position is
39.65664 degrees North latitude and 75.7767 degrees West longitude. In general, the higher the
number of satellites and the lower the Position Error Indicator number, the better the position
accuracy will be.
When the device is first started, it may take up to 2 minutes to acquire 5 satellites. During the
acquisition process the display will look something like this:
CONNECT FITTING 3
GPS Searching . . .
If after a few minutes, the SMART Scanner™ has still not acquired 5 satellites, you may try to follow
some of the suggestions in the GPS section on page 38, or you can bypass the GPS data by simply
connecting the fitting. The
SMART Scanner™ will show you a message similar to the following:
WAIT FOR GPS SIGNAL
PRESS TO IGNORE
IF YOU CHOOSE TO PRESS THE BUTTON, YOU WILL BE ABLE TO SCAN THE BARCODE AND COMPLETE THE
FUSION NORMALLY; HOWEVER, GPS DATA WILL NOT BE STORED WITH THE FUSION.