Roughneck Jackman Fusion Equipment, Руководство оператора

Страница: 23 / 52

JACKMAN FUSION EQUIP – ELECTROFUSION PROCESSOR OPERATORS MANUAL - REV 0
Page 21 of 48
ENTER BARCODE DATA
000000000000
000000000000
The cursor will begin under the first digit of the barcode. Enter the data from the barcode attached to the
fitting using the keypad
(see page 33). When the START button is pressed after the last character is entered,
the processor will move to the next screen.
If no errors were encountered, the Roughneck Electrofusion Processor will display a screen similar to the
following.
VERIFY SETUP
CPL 2
” COUPL
40.0V 60 sec
PRESS START
The VERIFY SETUP screen allows the operator a final opportunity to verify that the fusion parameters
displayed are correct and match the parameters specified by the fitting manufacturer before starting the
fusion.
ALWAYS pay close attention and verify the information on this screen is correct before pressing
START.
IT IS THE RESPONSIBILITY OF THE OPERATOR TO VERIFY THAT ALL THE INFORMATION DISPLAYED IS
CORRECT PER THE FITTING MANUFACTURER’S RECOMMENDATIONS FOR FUSING THE ATTACHED FITTING
UNDER THE CURRENT AMBIENT CONDITIONS.
The processor will BEEP once per second and the text “PRESS START” on the bottom line of the display will
flash on and off.
Once you have verified that all measurements and parameters are correct, press the START button to begin
the fusion.
If errors were encountered while decoding the barcode number that was manually entered, you will receive
an Error Message and will be forced to check the number and reenter it.
FAILURE TO VERIFY THAT THE FUSION INFORMATION IS CORRECT BEFORE STARTING A FUSION COULD
RESULT IN SIGNIFICANT DAMAGE TO PROPERTY, PERSONAL INJURY, AND/OR DEATH.
NOTE:
If Calculated Resistance is enabled and the operator receives a Warning Code 55, refer to the appropriate
section on page 35 for instructions that detail how to proceed.
See page 24 for instructions on monitoring the progress of a fusion.