Roughneck Jackman Fusion Equipment, Руководство оператора

Страница: 26 / 52

JACKMAN FUSION EQUIP – ELECTROFUSION PROCESSOR OPERATORS MANUAL - REV 0
Page 24 of 48
Monitoring a Fusion ’s Progress
Once the START button is pressed the fusion process will begin.
The fusion process begins with a Fitting Resistance Verification. The Roughneck Electrofusion Processor will
display a screen similar to the following:
VERIFYING FUSION
PARAMETERS
When operating in Barcode Fusion Mode, this resistance check is to make sure that the actual fitting
connected matches the resistance of the fitting described in the fusion parameters. When operating in an
Alternate Fusion Mode, this resistance check is used to verify that the fitting is still attached.
Although many
fittings have similar resistance measurements and this check is NOT fool-proof, it will help to ensure that
the correct fitting is attached.
If equipped with the optional GPS, the processor will next attempt to read the GPS coordinates. A screen
similar to the following will be displayed:
Waiting for GPS Data
STOP TO IGNORE
Once the coordinates are obtained, the fusion will proceed normally. To ignore the GPS data and force the
fusion to begin, press the
STOP button . If the GPS screen is bypassed, NO GPS DATA WILL BE STORED IN THE
PROCESSOR’S MEMORY .
As the fusion proceeds, the following screen will be displayed:
FUSION NUMBER: 0125
60 sec
Resistance: 2.63
This screen shows the number of the current fusion as well as the time remaining (in this case, 60 seconds). If
you want to see more detailed information, press and hold the
UP button to display the following fusion
information screen:
FUSION NUMBER: 00125
40.0V 15.2A
Energy: 0.085Ah
Gen: 118V 60.0Hz S